When the wax surrounding the nail melts, the nail clatters onto a plate below.

Spike growth

Upper Left

The nail fell.

Turn each middle screw and cast puck together making sure the puck is centered under the screw

Hand tighten each screw onto the puck until the puck stops turning

SJ I don't think it's there.

He asks, Might not the cotter pin have been defective?

I'll call it the allele straight for straight hair.

SJ I think it's under my right hand.

SJ Under my right hand.

AND THE RlGHT FRONT SCREW well above the pads

Set each screw by tightening an additional 10 degrees

Look straight.

Look straight.

How long, Max?

After adjusting the leveling screw, wait for at least 10 seconds for the bubble to stabilize

Take out the coolant pump to access the middle leveling screw on this side

So, now you don't know where the spike is, and I don't know where it is either, OK.

Now you don't know where the spike is, and I don't know where it is either.

I'm just pointing out, that maybe the nail is causing

Adjust the screw until the bubble is centered in the vial

Of course, I'm not bright about doing things but if you'll just bend the nail down, maybe I'll slip off and...

KB Now, Steve, do you think it's here? Yes or no?

Mm hmm. KB Now, Steve, do you think it's here?

KB OK. Do you think it's here, yes or no?

I think what you need is to get the nail out

If you want to get rid of me, screw you. I can blow up the whole thing.

Because it wasn't a spike that held him to the cross, it was His love for you and for me.

Three nights in a row.

She won eight bets in a row.

Now, Steve, you know where the spike is, but nobody else, does? Correct?

Do you think the spike is under your left hand, or under your right hand?

Now, Steve, you know where the spike is, but nobody else, does?

Do you think the spike is under your left or your right hand?

So let's say someone pokes you with this nail dipped in cow manure.

Is it improper to ask if maybe this cotter pin mightn't have been defective?

My ratings have been low have three consecutive years.

I'm an artist and a dad second time around.

I would repeat this process eight times in a row.

But that was the fourth straight time.

But I don't want you to know either, so swivel around on your chair.

Use a smaller torque value for aluminum jaws to avoid distorting the screw seats

Standing on the lower support frame will make it easier to reach the screw holes

So it's got all sorts of nasty stuff on it, pathogens on it, probably has a bunch of bacteria sitting in the cow manure.