When the wax surrounding the nail melts, the nail clatters onto a plate below.

Spike growth

Upper Left

The nail fell.

Turn each middle screw and cast puck together making sure the puck is centered under the screw

Hand tighten each screw onto the puck until the puck stops turning

SJ I don't think it's there.

He asks, Might not the cotter pin have been defective?

SJ I think it's under my right hand.

SJ Under my right hand.

AND THE RlGHT FRONT SCREW well above the pads

Set each screw by tightening an additional 10 degrees

After adjusting the leveling screw, wait for at least 10 seconds for the bubble to stabilize

Take out the coolant pump to access the middle leveling screw on this side

So, now you don't know where the spike is, and I don't know where it is either, OK.

Now you don't know where the spike is, and I don't know where it is either.

I'm just pointing out, that maybe the nail is causing

Adjust the screw until the bubble is centered in the vial

Of course, I'm not bright about doing things but if you'll just bend the nail down, maybe I'll slip off and...

KB Now, Steve, do you think it's here? Yes or no?

Mm hmm. KB Now, Steve, do you think it's here?

KB OK. Do you think it's here, yes or no?

I think what you need is to get the nail out

If you want to get rid of me, screw you. I can blow up the whole thing.

Because it wasn't a spike that held him to the cross, it was His love for you and for me.

Now, Steve, you know where the spike is, but nobody else, does? Correct?

Do you think the spike is under your left hand, or under your right hand?

Now, Steve, you know where the spike is, but nobody else, does?

Do you think the spike is under your left or your right hand?

So let's say someone pokes you with this nail dipped in cow manure.

Is it improper to ask if maybe this cotter pin mightn't have been defective?

But I don't want you to know either, so swivel around on your chair.

Use a smaller torque value for aluminum jaws to avoid distorting the screw seats

Standing on the lower support frame will make it easier to reach the screw holes

So it's got all sorts of nasty stuff on it, pathogens on it, probably has a bunch of bacteria sitting in the cow manure.

This time I've got to hand it to you. You hit the nail on the head.

leave the lower left corner screw in place but loose on top of the enclosure, detach the shipping bracket and remove the packing material

Using only the RlGHT REAR leveling screw make adjustments until the bubble is centered

I only ask because I had one bust off when I was fixing my kid's express wagon last week.

That's a huge asset. It's actually a relief. 'Cause it means you can screw up.

They're the next turn of this particular screw, which has been going on 20 years now.

They used a nail shape for ones, and a V on its side for tens, combining these symbols to write other numbers.

Check whether the LEFT FRONT leveling screw needs to be raised or lowered to bring the machine level

When the puck and screw have stopped turning by hand use the ratchet wrench to tighten the screw an additional 10 degrees of rotation

If it had, you'd expect to see a part of the shearedoff cotter pin in one of the holes, or scratches or marks or some bending to show where it had pulled out.