According to local statistics, in 2006, the population density in the city was 2,528 inhabitants per square kilometre.

This density, the highest in Germany, is partly due to the major musical production company Stage Entertainment being based in the city.

Population density in certain parts of Helsinki's inner city area is very high, reaching in the district of Kallio, but as a whole Helsinki's population density of ranks it as quite sparsely populated in comparison to other European capital cities.

At this altitude, the air density is about 1 2200000 the density on the surface.

Solid hydrogen has a density of 0.086 g cm3 making it one of the lowest density solids.

Most modern body composition laboratories today use the value of 1.1 kilograms per liter for the density of the fat free mass , a theoretical tissue composed of 72 water (density 0.993), 21 protein (density 1.340) and 7 mineral (density 3.000) by weight.

The density of air, ρ (Greek rho) (air density), is the mass per unit volume of Earth's atmosphere.

(The two effects would cancel at a surface rock density of 4 3 times the average density of the whole earth.

Average density of 4.58 individuals per km2.

Population density is 43.3 inhabitants per km2.

And so I started to think, well, you know, density, density I'm not sure if, you know, this was the right call.

The population density was 17 km² (44 mi²).

The population density was 780 km² (2020.19 mi²).

Some areas have a low density of targets.

Its population density is 75.8 inhabitants per square kilometre.

In some countries the population density is quite high.

The degree of ionization, formula_1, is defined as formula_2, where formula_3 is the number density of ions and formula_4 is the number density of neutral atoms.

The electron density is related to this by the average charge state formula_5 of the ions through formula_6, where formula_7 is the number density of electrons.

On the other hand, the high density of , 2.6 3.3 g cm3, suggests a very high non ice content (compare with Pluto's density 2.0 g cm3).

And he thought to himself, They go from one density of medium, the air, into another density of medium, water, without a splash. Look at this picture.

In mid 2010, there were 2,754,440 residents in the city proper, while some 4.2 million people lived in the greater Rome area (which can be approximately identified with its administrative metropolitan city, with a population density of about 800inhab. km2 stretching over more than 5,000 km²).

Its population density stands at 75.9 inhabitants per square kilometre.

Betelgeuse, however, has a much lower density than the Sun.

The city's population density is 718 inhabitants per square kilometre.

Population density is about 50 persons per km² (130 sq.

It belongs to the Low density lipoprotein receptor gene family.

Geology In geology the aspects of rock density are involved.

At the photosphere, the temperature has dropped to 5,700 K and the density to only 0.2 g m3 (about 1 6,000th the density of air at sea level).

It is not just about the density of transistors that can be achieved, but about the density of transistors at which the cost per transistor is the lowest.

These differences cannot be explained by wealth alone but are closely linked to the rates of walking, cycling, and public transport use and to enduring features of the city including urban density and urban design.

The population density was 78 people per square mile (30 km²).

The population density was 5 people per square mile (2 km²).

The population density was 196 people per square mile (76 km²).

It had the lowest population density of all the Danish counties.

It is similar to linen in absorbency, density and microscopic appearance.

Kelp forests are underwater areas with a high density of kelp.

The following is a list of islands, sorted by population density.

Uses DXA scans are used primarily to evaluate bone mineral density.

With a total area of , it has a population density of .

The population density was 24.8 people per square mile (9.6 km²).

It is defined as formula_1where formula_2 is the liquid phase mass flow rate formula_3 is the gas phase mass flow rate formula_4 is the gas density formula_5 is the liquid density.

Given a model of the density, the gravity measurements at the surface can be predicted but in an inverse problem the gravity measurements are known and the density must be inferred.

In the verbatim record, two words were uttered repeatedly density and saturation.

With a total area of , the province had a population density of .

Solid helium has a density of 0.214 0.006 g cm3 at 1.15 K and 66 atm the projected density at 0 K and 25 bar (2.5 MPa) is 0.187 0.009 g cm3.