Lathe

lathe

Lathe

Lathe

Welcome to the lathe soft jaw video series

Welcome to the Lathe soft jaw video series

The spindle sweep measurement will show that the spindle axis is perpendicular to the table surface

This Lathe is fully functional and installation is complete

Welcome to this How to Level a Haas Lathe video

We learned about the fundamentals of cutting lathe soft jaws

Place the work probe in the spindle

Attach the magnetic base to the spindle

Touch the spindle. Touch it, I say.

During automatic recovery, the spindle drawbar unclamps and you will hear a blast of air coming from the spindle nose

Along the bottom, we have the spindle information box with the override values for spindle speed, feed rate, and rapid rate

The spindle usually moves in the z axis.

The spindle warm up should now be complete

Attach the magnetic base to the spindle nose

Tilt along this axis influences how coolant and chips drain from the lathe

Regardless of which tool ends up in the spindle

Remember, spindle speed also affects outside diameter holding force

The spindle will turn at a maximum of 750rpm

Remove any tool that's in the spindle using TOOL RELEASE

Remove the fasteners holding the spindle head bracket in place

Select program O02020 Spindle Warm up and press SELECT PROGRAM

And we'll keep the spindle speed below the recommended 900 rpm

With the machine geometry verified, start the Spindle Warm Up program

A carpenter is using a lathe to shape the final leg of a hand crafted table.

If necessary, move the tailstock or 2nd spindle to the HOME position

To remove the spindle head bracket press Z , ZERO RETURN , and SlNGLE

Press CYCLE START and the spindle will begin turning at 500 rpm

Move the spindle head down to the middle of Z axis travel

She lays her hands to the distaff, and her hands hold the spindle.

She layeth her hands to the spindle, and her hands hold the distaff.

Along the bottom, we have the spindle information box with the override display

Place boxes filled with packing foam under the spindle and tool carousel pocket

Detach the Red Security Bracket between the Turret Face and the Spindle Bulkhead

If your program spindle speed does exceed 750rpm, the program will not run

Now they are the correct bore size and once again concentric to the spindle

The spindle sweep values are also affected by the precision of the leveling sequence

Errors because of twist or bow will cause errors in the spindle tram values

The pool is also featured briefly at the end of the 1979 TV adaptation of The Lathe of Heaven .

For DS models, detach the Security Bracket connecting the Second Spindle to the Machine Base

Take special note of how fast the spindle will be rotating during actual part machining

It's not a laborer it's simply an electronic lathe, so the parts can all be cut at the same time.