Spike growth

Upper Left

When the wax surrounding the nail melts, the nail clatters onto a plate below.

The nail fell.

Turn each middle screw and cast puck together making sure the puck is centered under the screw

SJ I don't think it's there.

He asks, Might not the cotter pin have been defective?

SJ I think it's under my right hand.

SJ Under my right hand.

AND THE RlGHT FRONT SCREW well above the pads

Set each screw by tightening an additional 10 degrees

So, now you don't know where the spike is, and I don't know where it is either, OK.

Now you don't know where the spike is, and I don't know where it is either.

I'm just pointing out, that maybe the nail is causing

Adjust the screw until the bubble is centered in the vial

Of course, I'm not bright about doing things but if you'll just bend the nail down, maybe I'll slip off and...

KB Now, Steve, do you think it's here? Yes or no?

Mm hmm. KB Now, Steve, do you think it's here?

KB OK. Do you think it's here, yes or no?

I think what you need is to get the nail out

If you want to get rid of me, screw you. I can blow up the whole thing.

Press

Now, Steve, you know where the spike is, but nobody else, does? Correct?

Do you think the spike is under your left hand, or under your right hand?

Now, Steve, you know where the spike is, but nobody else, does?

Do you think the spike is under your left or your right hand?

Hand tighten each screw onto the puck until the puck stops turning

So let's say someone pokes you with this nail dipped in cow manure.

Is it improper to ask if maybe this cotter pin mightn't have been defective?

Maison de presse

Press law

Oh, yes, the publicity.

Fight the press?

I will never use journalism for anything ... because journalism is my religion.

Ensure unfettered media market access for foreign electronic and print media organizations.

This was what many call immersion journalism, or undercover journalism.

But I don't want you to know either, so swivel around on your chair.

Use a smaller torque value for aluminum jaws to avoid distorting the screw seats

After adjusting the leveling screw, wait for at least 10 seconds for the bubble to stabilize

Standing on the lower support frame will make it easier to reach the screw holes

So it's got all sorts of nasty stuff on it, pathogens on it, probably has a bunch of bacteria sitting in the cow manure.

Take out the coolant pump to access the middle leveling screw on this side

This time I've got to hand it to you. You hit the nail on the head.

Bernanke Meets the Press

Don t Save the Press