Spike growth

Upper Left

When the wax surrounding the nail melts, the nail clatters onto a plate below.

The nail fell.

Turn each middle screw and cast puck together making sure the puck is centered under the screw

SJ I don't think it's there.

He asks, Might not the cotter pin have been defective?

SJ I think it's under my right hand.

SJ Under my right hand.

AND THE RlGHT FRONT SCREW well above the pads

Set each screw by tightening an additional 10 degrees

And the question was, here we do it by taking a sample, we put it in a centrifuge, we spin it, and you get blood cells out.

So, now you don't know where the spike is, and I don't know where it is either, OK.

Now you don't know where the spike is, and I don't know where it is either.

I'm just pointing out, that maybe the nail is causing

Adjust the screw until the bubble is centered in the vial

Of course, I'm not bright about doing things but if you'll just bend the nail down, maybe I'll slip off and...

KB Now, Steve, do you think it's here? Yes or no?

Mm hmm. KB Now, Steve, do you think it's here?

KB OK. Do you think it's here, yes or no?

I think what you need is to get the nail out

If you want to get rid of me, screw you. I can blow up the whole thing.

Now, Steve, you know where the spike is, but nobody else, does? Correct?

Do you think the spike is under your left hand, or under your right hand?

Now, Steve, you know where the spike is, but nobody else, does?

Do you think the spike is under your left or your right hand?

Hand tighten each screw onto the puck until the puck stops turning

From the daughter of Zion all her majesty is departed her princes are become like harts that find no pasture, they are gone without strength before the pursuer.

And from the daughter of Zion all her beauty is departed her princes are become like harts that find no pasture, and they are gone without strength before the pursuer.

So let's say someone pokes you with this nail dipped in cow manure.

Is it improper to ask if maybe this cotter pin mightn't have been defective?

But I don't want you to know either, so swivel around on your chair.

Use a smaller torque value for aluminum jaws to avoid distorting the screw seats

After adjusting the leveling screw, wait for at least 10 seconds for the bubble to stabilize

Standing on the lower support frame will make it easier to reach the screw holes

So it's got all sorts of nasty stuff on it, pathogens on it, probably has a bunch of bacteria sitting in the cow manure.

Take out the coolant pump to access the middle leveling screw on this side

This time I've got to hand it to you. You hit the nail on the head.

Using only the RlGHT REAR leveling screw make adjustments until the bubble is centered

I only ask because I had one bust off when I was fixing my kid's express wagon last week.

And the question was, here we do it by taking a sample, we put it in a centrifuge, we spin it, and you get blood cells out. Terrific.

That's a huge asset. It's actually a relief. 'Cause it means you can screw up.

Because it wasn't a spike that held him to the cross, it was His love for you and for me.

They're the next turn of this particular screw, which has been going on 20 years now.

They used a nail shape for ones, and a V on its side for tens, combining these symbols to write other numbers.