Move to the coolant pump area and attach the wash down hose assembly to the mounting point on the coolant manifold

It is recommended that the 1 2 hose is connected directly to the Hose Barb with a Hose Clamp

Connecting the 1 2 hose directly to the hose barb, with a hose clamp, is preferred

We have a faster hose, and then we have a slower hose.

Place the standard coolant pump next and connect the 3 4 coolant line from the coolant manifold to the pump

Hi TedxKhartoum

See you in TedxKhartoum!

For parking alongside of a fireplug.

Come on and get that hose!

Print a nozzle test pattern

So let's think about each of the hoses.

And I'm going to insert a coolant command

Hey, lady. That's a fireplug.

I'm not parked next to a fireplug.

And there is the coolant command inserted into the program

It's against the law to park alongside one. I know it.

I wanted to turn coolant on, I had forgotten it

Maybe I forgot to turn coolant on before a particular tool

How long does each hose take to fill the pond by itself?

Normally, the heat from a flue powers an absorptive chiller .

When the decays, it causes a buildup of magnesium in the coolant.

A significant modification was also made to the entry for primary coolant pumps

You don't want you can imagine a hose if it bent a

little bit is using a hose to fill his new swimming pool for the first time.

I don't suppose it will make any difference, but you're parked in front of a fireplug.

leaving the machine clean with nothing remaining to contaminate the customer's coolant

Here's a sample of our plastic hose, manufactured exclusively by PLASTAC.

Connect the electrical cord from the standard Coolant Pump to the receptacle labeled Coolant

Tilt along this axis influences how coolant and chips drain from the lathe

Take out the coolant pump to access the middle leveling screw on this side

Amen is or maybe A man, I don't know the best way to pronounce that name is using a hose let me scroll over a

The amount that we're full is directly proportional to the amount of time that we let the hose run.

I was using the cocktail shaker. It's the only thing I found.

The mean temperature of the hot coolant leaving the reactor core was designed to be 648 C.

And they land on the flower. They stick their tongue in there, called a proboscis, and they drink sugar water.

They land on the flower, stick their tongue in there, called a proboscis, and drink sugar water.

Apply pipe thread sealant to the air gun hose fitting and fasten it tightly to the connecting point

I don't care who you are, I just want you to know you can't park beside a fireplug.

Second, level the machine front to back and side to side to permit good coolant and chip flow

And then I can't tell you how hard it is to do that radiator, which is curved.

leaving the machine clean with nothing left to contaminate the customer's coolant remove the screws from the shipping bracket

This combination eliminates the need for a separate low pressure hose for the BC, though the low pressure hose for the combined use must be larger than standard BC inflation hoses, because demand on it will be higher if it is used for breathing.

A coat on a fence would make them balk, shadows would make them balk, a hose on the floor ... people weren't noticing these things a chain hanging down and that's shown very, very nicely in the movie.

Remove all signs of Cosmoline and WD 40, leaving the Machine clean with nothing remaining to contaminate the customer's Coolant

People thought that was crazy. A coat on a fence would make them balk, shadows would make them balk, a hose on the floor ...