What next?

For my friends!

Attach the magnetic base to the spindle

Attach the magnetic base to the spindle nose

Touch the spindle. Touch it, I say.

During automatic recovery, the spindle drawbar unclamps and you will hear a blast of air coming from the spindle nose

She lays her hands to the distaff, and her hands hold the spindle.

She layeth her hands to the spindle, and her hands hold the distaff.

The spindle warm up should now be complete

Remove the fasteners holding the spindle head bracket in place

Select program O02020 Spindle Warm up and press SELECT PROGRAM

The spindle sweep values are also affected by the precision of the leveling sequence

Detach the Red Security Bracket between the Turret Face and the Spindle Bulkhead

It's going to be, as it migrates to either side it's going to initiate the formation of the spindle.

Move the spindle head down to the middle of Z axis travel

Place boxes filled with packing foam under the spindle and tool carousel pocket

The spindle will turn at a maximum of 750rpm

To remove the spindle head bracket press Z , ZERO RETURN , and SlNGLE

With the machine geometry verified, start the Spindle Warm Up program

Sweet Princess, if through this wicked witch's trick... a spindle should your finger prick, a ray of hope there still may be in this, the gift I give to thee.

If necessary, move the tailstock or 2nd spindle to the HOME position

I decided that I did not want to stop the spindle so I wrote myself a note

Take special note of how fast the spindle will be rotating during actual part machining

The spindle sweep measurement will show that the spindle axis is perpendicular to the table surface

The minute you offer the generals command... they start wheezing like winded mules.

Attach leveling tool T 2192 to the spindle housing with the precision level parallel to the X axis

Errors because of twist or bow will cause errors in the spindle tram values

With the turret still beside the spindle note the exact position of the bubble in the vial window

So I have my magenta one here, I have my magenta one here, and I have my other one here, my green one there, and, of course, you have your centrosomes, the microspindles that are coming off of them.

Re measuring for Twist and measuring for Bow in the base casting and then measuring the Spindle Sweep.

In this case, the spindle drawbar will need to be set to the unclamped position during the tool removal

Now use shop towels to clean the Y axis linear guides and the underside of the spindle head and ram

Raise the right front corner until the indicating bubble has moved to the exact position established at the spindle side of the machine

Once settled, move the turret back across full Z axis travel to the spindle side and note which direction the level is tilting

If the adjustments to make spindle sweep better are very small you don't need to check bow and twist again

This is the 20th century.

For Gandhi, the spinning wheel symbolized the need to assume personal responsibility for consumption as a first step toward achieving justice and freedom for all.

If the spindle sweep is not within specification along the Y axis, we can use the middle screws to make very small adjustments to the sweep readings while changing the bow and twist values by a negligible amount

This century must be an American Century.

It is the first century of the 3rd millennium.

The 19th century culture was defined by the novel, the 20th century culture was defined by the cinema, and the culture of the 21st century will be defined by the interface.

French Horn

English Horn

If not, it will scan through the list and find the first back up tool that does have life remaining and call that tool to the spindle

On a number line, our Total Indicator Reading is three ten thousandths (0.0003 or 0.0076mm) TlR which puts our spindle sweep measurement in specification